Placing The Ceramic Lumber Set (Only For Natural Gas) - WANDERS Norma Mode D'emploi Et Instructions D'installation

Setting the desired temperature
Press and hold the AUTO button until the T EMP indication
blinks. You can set a higher temperature with the ▲
button and a lower temperature with the ▼ button. Then
wait a few seconds, or press the AUTO button to switch
to the automatic modus.
Checking the set temperature
Briefly press the AUTO button. The display briefly shows
the preset temperature and then displays the room
temperature.
TIMER
You can preset a total of four time-settings. When you
link up all four time-settings, you can be sure of a
comfortable room temperature at all times.
Press and hold the TIMER button until the indication
P1<☼> blinks. With the ▲ and ▼ buttons you can
set respectively the hours and the minutes. By briefly
pressing the TIMER button you can browse through the
timer programme P1<☼>, P1<>, P<☼> and P<>.
Here is an example of a possible presetting.
P1<☼>-temp: 07:0 - 08:0 the preset temperature
P1<>-temp: 08:0 - 17:00 off
P<☼>-temp: 17:00 - :00 the preset temperature
P<>-temp: :00 - 07:0 off
The TIMER function works only when the pilot flame is
on. If the TIMER mode is switched on, the temperature
control will be the same as in the AUTO position. You
can switch off the TIMER mode with the ▲ and ▼
buttons. The remote control will automatically switch to
the MAN function.
MAN
When the display shows the MAN position you can
manually turn the hearth higher ▲ and lower ▼ by
using the big buttons. When you press and hold the ▼
button the hearth will go to its lowest position: the pilot
flame. When you keep these buttons pressed, you will
see the 'transmit' symbol top left in the display. You will
know when the hearth has reached its highest or lowest
position when the LED of the receiver starts blinking.
Placing the ceramic lumber set (only
for natural gas)
• How to open the door is explained on page 18
• Place some pieces of ceramic bark exactly as shown
in the illustrations. Start with four pieces of bark on
the burner but do not block the outflow passage of the
pilot.
• Place the ceramic logs exactly as shown in the
illustrations. This will give regular flames and prevents
0
soot build-up.
• Place the rest of the bark in the empty spaces around
the logs. Do not place them on the burner.
• PLEASE NOTE: Be sure not to touch the cleaned glass
with your fingers when you replace the pane. Finger
marks burn in the glass.
• Do not forget to replace the door correctly and close
it before lighting the hearth.