Chin Strap - shark Varial Manuel D'utilisation

WARNING! Never use the strap loop to
secure your helmet to your head. In order to
be properly fastened, you must thread the strap
through the double-D-rings. Failure to properly
use the double-D-rings will cause your helmet
to become dislodged during an accident, leaving
your head completely unprotected and resulting
in severe head injury or death. Try to pull down
on the chin strap with your fingers. If the strap
loosens in any way, you have not properly tightened
DOUBLE-D RING
A - Slide the long part of the chin strap through
the two D rings, positioning the comfort pad correctly
between the chin strap and your neck.
B - Then bring the end of the chin strap back through
the lower of the two D rings as shown in the diagram.
C
A
the chin strap with the double-D rings.
Repeat the steps above. Never ride with the chin strap
loose, improperly fastened or improperly positioned.
Even though the comfort padding gives you the
impression that the helmet is securely held in place,
it will come off in an accident, leaving your head
completely unprotected.
If you have any doubt concerning the fastening
system of your helmet, do not use the helmet. Contact
your dealer for assistance.
C - Pull the strap until you feel resistance from
the strap and it is held in place under your chin
without being too tight, so that you have no
difficulty in breathing.
D - Slide the free end of the chin strap into the plastic
strap loop on the comfort padding, in order to prevent
the strap from fluttering in the wind.

CHIN STRAP

B
D
7