REPLACING THE INTERIOR PADDING
1. Replace the front part of the padding beginning
with the central tongue (Fig. A1). Warning: The
tongue must be fully extended into its 3 slots
(Fig. A2).
2. Close the 2 snap buttons on the back part of
the padding (Fig. B).
3. Reposition the cheek pads by inserting the chin
strap into the foam slit. Now close all the snap
buttons (Fig. C).
WARNING! The interior padding is critical
to maintain the correct fit of the helmet
on your head. If you have any doubt whatsoever
regarding the removal or replacement of the inte-
rior padding, DO NOT USE YOUR HELMET. Contact
your retailer for assistance or advice. NEVER use
your helmet with any part of the interior padding
removed. The helmet will not protect you in an
accident.
WARNING! The polystyrene lining and inte-
rior padding are critical to properly fit your
helmet on your head. An improper fit could cause
your helmet to become dislodged in an accident,
leaving your head unprotected and resulting in
severe head injury or death. If you are not sure
that you properly replaced the comfort padding,
DO NOT USE YOUR HELMET. Contact your retailer
for assistance or advise.
2
1
A
B
C
TEXTILE PARTS
2
9