Advice For Use • Peak • Chin Guard; Putting On The Helmet; Removing The Helmet - shark Varial Manuel D'utilisation

ADVICE FOR USE • PEAK • CHIN GUARD

1/ PUTTING ON THE HELMET

To put on the helmet, take hold of the two
sections by the buckles and hold them slightly
apart to facilitate the passage of your head (chin
strap released).
While carrying out this movement, you are
advised to keep the two sections of the chin strap
apart with your thumbs so that they are properly
positioned.
Position the protective parts of the chin strap
buckle correctly and fasten it in accordance with
the recommendations that are appropriate to the
versions and country.
Check that the tension and therefore the
positioning of the helmet are correct for all
positions.

2/ REMOVING THE HELMET

Unhook the chin strap and hold the two sections
slightly apart as for putting the helmet on and
remove the helmet.
3/ PEAK DISASSEMBLY.
1. Unscrew the 2 side screws (Fig. A).
2. Remove the screw located on the front part
of the peak (Fig. B).
6
4/ BAR DISMANTLING / ASSEMBLY.
1. Press the lever found inside the chin guard
(Fig. C).
2. Remove the cover (Fig. D) and then the bar
(Fig. E).
3. For the assembly step, position the bar and
then clip the cover.
C
D
A
B
E