Connection To The Evaluation Unit - Balluff BTL7-S5 Série Notice D'utilisation

BTL7-S5 _ _ D-M _ _ _ _ -T _ 2/3-S32/KA _ _ /FA _ _
Magnetostrictive Linear Position Sensor – Rod Style
8
Technical data (continued)
8.7

Connection to the evaluation unit

The maximum sampling frequency f
current value is available with each sampling, can be found
in the following graphic:
f in Hz
A,max
Fig. 8-1: Maximum sampling rate depending on the nominal length
(for position output).
The maximum SSI clock frequency f
the cable length :
1)
f in kHz
Clk, max
Fig. 8-2: Maximum SSI clock frequency depending on the cable
length
20 english
, at which a new
A,max
is dependent on
CLK, max
The minimum sampling rate f
A,min
Nominal length in mm
Cable length in m
For longer length: required cable cross-section ≥ 0.6 mm
1)
is 62.5 Hz.
(1) 1 magnet
(2) 2 magnets
and ≤ AWG19
2