Scope Of Delivery; Legend; User Interface (Ui); Installation (Fig. 2A+B) - M-E Vistadoor Vistus VDV-907 Mode D'emploi

VDV-907 | ENGLISH
VDV-907 indoor unit
for video door intercom systems
Thank you for purchasing this video indoor
unit with integrated picture memory and
WLAN function. This indoor unit can be com-
bined with all components from the VISTA-
DOOR and VISTUS door intercom systems.
When the bell is rung at the connected out-
door unit, the indoor unit plays the set rin-
ging melody and the visitor can be seen on
the monitor. Furthermore, 3 photos are auto-
matically saved.
You can speak to the visitor at the indoor unit
GB
and also open the door (if a door opener is
connected).
If the VDV-907 is connected via WLAN, a
connection to your smartphone can also be
established. At www.vistasmart.de you will
find more information on how to install the
app and integrate the VDV-907.
This indoor unit has two card slots for mi-
croSD cards (max. 32GB).
Audio files can be stored on a microSD card in
slot 1 (8), which can then be used as a ringto-
ne. For the picture storage function, another
microSD card is required in slot 2 (9). No me-
mory cards are included in the scope
of delivery.

SCOPE OF DELIVERY

- Indoor unit with 7" screen diagonal
- Mounting material
- Operating and installation instructions
- Drilling template

LEGEND

1 = VDV 907
2 = Microphone
3 = Silence button (sensor touch)
4 = Door release button (sensor touch)
5 = Talk button (sensor touch)
6 = Housing screws
7 = Touch-active surface
8 = MicroSD slot 2 photos
9 = MicroSD slot 1 ring tones
37

User interface (UI)

A1 = Light key
A2 = Shift keys
A3 = Alarm key
A4 = Name of outdoor unit
A5 = Time / date display
A6 = Photo button
A7 = Voice volume
A8 = Mute button
A9 = Change outdoor unit name
A10 = Settings
A11 = Back button
A12 = Picture memory key
B1 = Language
B2 = Speech volume
B3 = Time / date
B4 = Previous page
B5 = Basic settings
B6 = Next page
B7 = Melody indoor unit
B8 = Help
B9 = Picture settings
B10 = WLAN settings
B11 = Information
B12 = Delete all photos
B13 = Factory settings
B14 = Radio chime melody
38
ENGLISH | VDV-907

INSTALLATION (Fig. 2a+b)

1. Find a suitable place to install the indoor
unit and run the cables to it.
2. Remove the two screws (16) on the indoor
unit and lift off the front cover of the
indoor unit.
3. There are two plastic retaining lugs in the
centre of the sides of the indoor unit.
Carefully pull off the front cover.
4. There is a hole in the top of the housing
below the connection terminals for
inserting the cables into the housing.
5. You can use the bottom of the housing as
a drilling template, align it with a spirit
level just at the point on the wall where
the indoor unit is to be mounted.
6. Mark the holes on the wall with a suitable
pencil, then drill the holes (Ø 6 mm) at the
marks.
7. Insert one of the plugs supplied into each
hole.
8. Lead the connection cable through the
hole in the housing base of the indoor unit
and screw the housing base to the wall
with four screws.
9. Connect the cables as shown in the
connection diagram (Fig. 4).
GB