Electrical Safety - Gardeo GTDE1842I-2L Traduction Des Instructions D'origine

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

correspond to the types indicated by
the manufacturer.
See the operating instructions for
the order no. and types.
Never touch the mains plug with
wet hands.
Do not run over, crush or pull the
power supply cable or extension
lead, otherwise it may be damaged.
Protect the cable from heat, oil and
sharp edges.
WARNING: Packaging
materials are not toys!
Children must not play
with plastic bags!
Danger of suffocation!
Never allow children or people
unfamiliar with these instructions to
use the machine.
Local regulations may restrict the
age of the operator. When not in
use store the machine
out of reach of children.
This tool is not intended for use
by persons (including children) with
reduced physical,
sensory or mental capabilities, or
lack of experience and knowledge,
unless they have
been given supervision or
instruction concerning use of the
appliance by a person responsible
for their safety.
It should supervise children to
ensure they do not play with the
device.
The extension lead must have a
cross section in accordance with the
operating instructions and be
protected against splashed water.
The connection must not be in
water.
Always wear gardening gloves
when handling or working near the
sharp blades.

ELECTRICAL SAFETY

Always check that
supply corresponds
voltage on the rating
Warning! Switch off, remove plug
from mains before adjusting,
cleaning or if cable is cut, damaged
or entangled.
The blades continue to rotate for
a few seconds after the machine is
switched off.
Caution – do not touch the
rotating blade.
Your machine is double insulated
for safety and requires no earth
connection. The operating voltage is
230 V AC, 50 Hz (for non-EU
countries 220 V, 240 V as
applicable). Only use approved
extension cables. Contact your
GARDEO Service Centre for details
: sav@eco-repa.com
Extension cords/leads should only
be used if they comply with H05VV-
F, H05RN-F types or IEC type
design (60227 IEC 53, 60245 IEC
57).
If you want to use an extension
cable when operating your product,
only the following cable dimensions
should be used:
– 1.0 mm²: max. length 40 m
– 1.5 mm²: max. length 60 m
– 2.5 mm²: max. length 100 m
Note: If an extension cable is used it
must be earthed and connected
through the plug to the earth cable
of your supply network in
the power
to the
plate.
39

Publicité

Table des Matières
loading

Table des Matières