Cleaning And Maintenance; Technical Data - Gardeo GTDE1842I-2L Traduction Des Instructions D'origine

CLEANING AND MAINTENANCE

Before performing any work
on the equipment, pull out
> Cleaning
§ Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it with
compressed air at low pressure.
§ We recommend that you clean the device
immediately each time you have finished using it.
§ Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents or
solvents; these could attack the plastic parts of the
equipment. Ensure that no water can seep into the
device.
Never use solvents such as
petrol, alcohol, ammonia
water, etc. These solvents
may damage the plastic
> Blade maintenance
§ Regularly remove grass and dirt from the blade.
§ At the beginning of the gardening season,
carefully examine the condition of the blade.
§ If the blade is very blunt, sharpen or replace the
blade.
§ If the blade is damaged or worn, fit a new blade.
Observe the following
§ Disconnect the mower from the mains and wait
until the blade has stopped rotating before
proceeding.
§ Be careful not to cut yourself. Use heavy-duty
gloves or a cloth to grip the blade.
§ Only use the specified replacement blade.
§ Do not remove the impeller (A)for any reason.
> Replacing the blade
For safety reasons, we recommend having the
blade replaced by an authorized professional.
Important: Wear work gloves!
Attention!
the power plug.
parts.
Warning!
precautions:
«
Fig E »
Replacement blade, as this will ensure top
performance and safety under all conditions. Carry
out the following steps to change the blade:
§ Turn the mower onto its side.
§ Grip the blade( C) with one hand.
§ Use a wrench (not supplied) to loosen and remove
the blade nut (B).
§ Replace the blade
§ Securely tighten the blade nut.

TECHNICAL DATA

Rated Voltage
Rated Frequency
Rated Power
Rotation speed
Cutting width
Blade
Protection class
Int. protection degree
Collect box / bag
Cutting heights
Induction motor
Weight
Noise emission values measured according to
relevant standard :
Acoustic pressure level L
80.5 dB(A)
Acoustic power level L
WA
92.1 dB(A)
Guaranteed sound power
The sound power pressure may
exceed 85 dB(A), in this case
individual hearing protection
Weighted root mean square acceleration according
to relevant standard. : 2.28 m/s²
The declared vibration total value has
been measured in accordance with a standard
test method and may be used for comparing one
tool with another that the declared vibration total
value may also be used in a preliminary
assessment of exposure.
230-240 V
50Hz
1800W
-1
2850 min
42 cm
R8098-500001
Class II
IP24
50 L
5 positions
25-35-45-55-75mm
Yes
19.5 Kg
PA
K = 3 dB(A)
K = 2.07 dB(A)
L 96 dB(A)
WA
ATTENTION !
must be worn.
K = 1.5 m/s²
42