Adjusting The Position - Glatz AMBIENTE Instructions De Montage Et D'emploi

3.3 Adjusting the position

3.3.1 Basic alignment
(a) Swivelling the carrier arm (figures 6 and 7)
• Remove the lower connection bolt (6) from the mast.
• Push up the cover plate (7).
• Loosen all anchoring screws (8) by a ½ turn.
• Swivel the opened sunshade to the required position (4).
• If necessary, carry out the correction (5) before tighten the loosened
screws.
(b) Rotating the sunshade in its suspension (figures 6 and 8)
Only necessary in the case of rectangular and square sunshades.
• With the sunshade still closed, loosen the setting screw (10) by a ¼
turn.
• Open the sunshade and move to the required position.
• Tighten all the loosened screws again.
3.3.2 Adjusting the levelling
(c) Forward and backward angle of shade roof (figures 4 and 8)
• With the sunshade open determine the difference in height between
inside and outside edges (2).
• Close the sunshade and adjust by means of the levelling screw
(11). One complete of the screw in a clockwise direction causes the
outside edge to sink by approx. 4 cm and the inner edge to rise by
the same amount.
• Secure the levelling screw (11) with the counternut.
5
4
Fig. 6
11
7
12
8a
Fig. 8
EN
|
17
Fig. 7
6
9
8
2
1
Fig. 4