Disassembling; Taking Down The Sunshade - Glatz AMBIENTE Instructions De Montage Et D'emploi

EN
|
18
(d) Side angle of shade roof (figures 5 and 7)
• Determine the difference in high between the side edges of the
sunshade.
• Uncover the anchoring screws (8) by removing the lower connecting
bolt (6) and lifting off the screw cover (7).
• Leave the anchoring screw located behind the mast (8a) screwed
tight and loosen the other four anchoring screws (8) by ½ turn.
• Screw in the levelling screw (9) on the side of the lower lying edge
in a clockwise direction. One complete turn of the screw causes this
edge to rise approx. 4 cm.
• After levelling out, screw all anchoring screws (8) tight.
Fig. 7
6
7
9
8
8a

4. DISASSEMBLING

4.1 Taking down the sunshade (2 persons are necessary for this)
• Remove any obstacles in the area for laying the sunshade down.
• Remove connection bolts (1).
• Lift the sunshade until it is possible to lay it over to the rear. Lay
down carefully.
• If necessary, disconnect any electric cables.
• Unscrew support tube (2) and insert into the mast again.
• Close off the ground socket (3) with cover (4).
3
Fig. 5
2
1
3
4
Fig. 9