Nozzle Maintenance - shark APEX duo clean ZERO M ZS360 Série Guide Du Propriétaire

MAINTENANCE
CHECKING FOR BLOCKAGES
CHECK HANDHELD
Remove the wand from the handheld vacuum and
check all dust cup intake openings.
CHECK FLOOR NOZZLE
Detach the wand. To open the brushroll garage, slide
both release buttons on the floor nozzle away from
you, towards the back of the nozzle, then lift off the lid.
Tilt back the neck of the nozzle and check openings
for blockages. To close the brushroll garage, insert
the 3 tabs on top of lid into the 3 slots in the nozzle,
then push down firmly on both sides of the lid until it
clicks securely into place.
s h a r kc l e a n . c o m
CHECK WAND
Detach the wand and check it for blockages.
MAINTENANCE

NOZZLE MAINTENANCE

CLEANING THE BRUSHROLLS
1 To open the brushroll garage, slide both release buttons on the floor nozzle away from you, towards the
back of the nozzle, then lift off the lid.
2 Clear away any objects or debris.
3 To close the brushroll garage, insert the 3 tabs on top of lid into the 3 slots in the nozzle, then push down
on both sides of lid until it clicks securely into place. If Brushroll Indicator Light isn't green and headlights
are flashing, check again that both sides of lid are locked in place.
NOTE: If any hair is wrapped around the brushroll, continue cleaning, using Carpet mode on a bare floor surface, a low-pile
carpet, or a small area rug. This will allow Zero-M technology to remove the hair wrap and send it to the dust cup. If some
fibers remain wrapped around the brushroll after continued use, carefully remove them.
CLEANING THE SOFT ROLLER
1
To remove Soft Roller from nozzle, first open the brushroll garage, then pull the Soft Roller out by the tab.
2 Tap loose debris off the Soft Roller. Use a dry towel to wipe the Soft Roller clean, and to remove any debris
caught in the teeth behind the Soft Roller.
3 Hand wash the Soft Roller as needed. Use only water, and let air-dry completely for at least 24 hours.
4 Reinsert the Soft Roller and close the brushroll garage by inserting the 3 tabs on top of the lid into the 3 slots
in the nozzle. Then push down on both sides of the lid until it clicks securely into place. If Brushroll Indicator
Light isn't green and headlights are flashing, check again that both sides of the lid are locked in place.
NOTE: With normal use, you may need to perform routine maintenance of your Soft Roller.
1
s h a r kc l e a n . c o m
2