Floor Nozzle; Checking For Blockages - shark CORDLESS VERTEX PRO MultiFLEX IZ600 Serie Guide D'utilisation

MAINTAINING YOUR VACUUM

FLOOR NOZZLE

FLOOR NOZZLE
If any hair is wrapped around the brushroll, continue cleaning using the Carpet setting on a bare floor surface,
a low-pile carpet, or a small area rug. This will allow the self-cleaning brushroll to remove the hair wrap and
send it to the dust cup. If some fibers remain wrapped around the brushroll after continued use, carefully
remove them. If you run over a hard or sharp object or notice a change in noise while vacuuming, check the
floor nozzle for blockages. (See the Checking for Blockages in the Floor Nozzle section.)
CLEANING SOFT ROLLER
s h a r kc l e a n . c o m
1
To remove Soft Roller from nozzle, pull the Soft Roller out by
the tab.
2 Tap loose debris off the Soft Roller. Use a dry towel to wipe
the Soft Roller clean and to remove any debris caught in the
teeth behind the Soft Roller.
3 Hand wash the Soft Roller as needed. Use only water, and let
air-dry completely, which should take at least 24 hours.
4 Reinsert Soft Roller until you feel it click into place.
MAINTAINING YOUR VACUUM

CHECKING FOR BLOCKAGES

Checking for Blockages in the Handheld Vacuum:
1. Turn off vacuum.
2. Remove the handheld vacuum from the wand.
3. Check all intake openings on the dust cup and remove
any debris or blockage.
Checking for Blockages in the Wand:
Standard Wand:
1. Turn off vacuum.
2. Remove the handheld
vacuum and floor nozzle.
3. Look through wand to
check for any blockages.
4. Clear away debris and
blockages.
Checking for Blockages in the Floor Nozzle:
1. Turn off vacuum.
2. Detach the wand.
3. Use the edge of a coin to open the three locks on the
bottom of the floor nozzle.
4. Remove the cover and tilt back the neck of the floor
nozzle.
5. Check the opening and remove any debris.
6. Replace the cover by sliding the inserts into the slots, then
pressing down firmly on all sides before turning the locks
clockwise to close, until they click securely into place.
MultiFLEX® Wand:
1. Turn off vacuum.
2. Remove the handheld
vacuum and floor nozzle
from the wand.
3. Check the Clog Access
Hose on the MultiFLEX
section of the wand by
pinching the tabs on both
sides of the hose and
lifting the hose out.
4. Clear any debris and
blockages.
sharkclean.com