Maintenance; Emptying The Dust Cup; Cleaning The Filters - shark ROTATOR NV682 Mode D'emploi

MAINTENANCE

To keep your vacuum's suction power optimal, follow these instructions.
Make sure unit is off and cord unplugged.
IMPORTANT: Allow ALL filters to dry completely before replacing into the vacuum.
STEP 1
EMPTY THE DUST CUP
1 Pull up on the dust cup release latch and lift the dust
cup off the pod.
CLEAN THE FILTERS
1 With the dust cup removed, remove and rinse the foam
and felt filters every 3 months. Let air dry completely
before replacing. Hand wash only. Tap loose dirt off
filters between washes as needed.
RECOMMENDED FILTER CLEANING SCHEDULE:
Pre-motor Filter Kit (Foam & Felt):
Post Motor Filter:
2 Holding the dust cup over a garbage bag or can, press the
bottom empty release latch.
2 Once a year open the filter grill and remove and
rinse the HEPA filter. Let air dry completely before
replacing. Hand wash only.
IMPORTANT: DO NOT PICK UP FIREPLACE ASH
OR DRYWALL DUST.
Every 3 months
XFF680
Every year
XHF680
STEP 2
1. 8 0 0 . 7 9 8 . 7 3 9 8
STEP 3
3 Press the top dust cup release latch to access the dust
screen and remove built-up debris as required.
FOAM FILTER
FILTER FRAME
FELT FILTER
HEPA
1 0