Checking For Blockages; Nozzle Mainenance; Cleaning The Soft Roller - shark DuoClean HZ500EU Serie Instructions

MAINTENANCE

CHECKING FOR BLOCKAGES

CHECK HANDHELD
Remove the handheld vacuum from the wand
and check all dust cup intake openings.
CHECK FLOOR NOZZLE
Detach the wand, then remove the Soft Roller.
Tilt the floor nozzle tube back and check
openings for blockages. Reinsert Soft Roller
until it clicks securely into place.
Remove any blockages or debris from the floor
nozzle debris intake (See Nozzle Maintenance
section).
46 sharkclean.eu
CHECK WAND
Detach the wand and check it for
blockages.
MAINTENANCE
NOZZLE MAINTENANCE

CLEANING THE SOFT ROLLER

NOTE: For best performance, keep the Soft Roller clean with regular maintenance.
Anti Hair Wrap Technology removes hair
from your brush-roll continuously as you
vacuum. At times you may see small amounts
of hair around the brush-roll – simply
continue vacuuming and the comb and
suction will remove the hair as you clean.
To remove the cover, use a coin to turn the
locks counterclockwise. Lift off the cover
and remove any debris or hair wrap. Check
the Debris Intake and clear away any dirt or
blockages.
To close the cover, push down until it clicks
into place, then turn the locks clockwise
until closed.
1 To remove the Soft Roller, slide the Eject
Roller button on the floor nozzle.
2 Tap loose debris off the Soft Roller. Use a
dry towel to wipe it clean, and to remove
any debris caught in the teeth behind the
Soft Roller.
3 Hand-wash the Soft Roller as needed. Use
only water, and let it air-dry completely for
at least
24 hours.
4 Reinsert the Soft Roller and press it in until
it clicks securely into place.
sharkclean.eu 47