9.1
INPUT
COMMANDS
The scale can be controlled with the following commands. The commands must be
sent in upper case letters, i.e. "T" not "t". Press the Enter key of the PC after each
command.
T<cr><lf>
Tares the scale to display the net weight. This is the same as
pressing [Tare] key.
Z<cr><If>
Sets the zero point for all subsequent weighing. The display shows
zero. Same as pressing the [Zero] key.
P<cr><lf>
Prints the weight, unit weight and totals same as pressing the
[Print] key.
R<cr><lf>
Recall and Print, Same as if first the [MR] key and then the [Print]
key is pressed. Will display the current accumulated memory and
print the total results.
C<cr><lf>
Same as pressing [MR] first and then the [CE] key to erase the
current memory.
FORMAT
© Adam Equipment Company 2011