4 1 Settings Via The Menu - Monacor International JTS RU-G3TB/5 Mode D'emploi

3.4.1 Settings via the menu
1) Keep the button SET (11) pressed for 2 sec-
onds until SEtUP is briefly shown on the dis-
play (fig 1, page 10)
2) Press the button SET repeatedly until the
menu item desired is shown
3) Use the button

setting; then press the button SET again to
save the setting The display will briefly show
StorE as a confirmation; then the menu will
be exited
4) To exit the menu without any changes, press
the button SET repeatedly until CAnCEL is
briefly shown on the display
Menu item Setting
Group 1 – 6 and channel 1 – 22*
For simultaneous operation of multiple
wireless microphones, 6 groups with up
to 22 channels each have been defined
(see page 15). The number of channels
from a group that can be used at the
same time depends on the conditions at
the place of application.
First set the group number (left digit),
then press SET and set the channel num-
ber. Press SET to save the settings.
Transmission frequency*
as an alternative to selection of group
and channel
First adjust the frequency in steps of
1 MHz, then press SET and make a fine
adjustment in steps of 0.025 MHz. Press
SET to save the adjustments.
Microphone sensitivity
to match the microphone to the volume
of the voice / instrument
Adjust the sensitivity according to the
indication AF of the receiver in such
a way that an optimum signal level is
obtained. If the sensitivity is too high,
the microphone signal will distort; in this
case, press the button
value (min. −15 dB). If the volume is too
low, there will be a poor signal-to-noise
ratio; in this case, press the button
set a higher value (max. +15 dB).
* For interference-free transmission, switch off the pocket
transmitter and set the group and the channel or the fre-
quency on the receiver. If no interference or signals of other
transmitters are received, switch on the pocket transmitter
and make the same settings on the pocket transmitter.
or (10) to make the

to set a lower


Menu item Setting
20 dB attenuation when high microphone
levels result in distortions
AttOFF = no 20 dB attenuation (button
AttOn = attenuation activated (button
Transmission power (RF Power)
Use the button
power to Hi = high transmission power
(50 mW) for a long range, but a short
battery life or
use the button
power to Lo = low transmission power
(10 mW) for a long battery life, but a
short range
Automatic switch-off
when the microphone is muted, to save
the batteries
Adjustable time: 1, 10, 30 minutes and
OFF (= no automatic switch-off)
When 30, 10 or 1 are set as switch-off
time,
Key lock
to protect the transmitter against inad-
vertent switch-off or operation
Use the button
(indication LocOn, the symbol
on the display), then press SET to save.
When a button is pressed, LocOn will be
shown on the display.
To disable the key lock, keep the button
SET pressed for 3 seconds until On starts
flashing; press the button
the button SET to save.
Fig. 4 Setting options via the menu
to
to set the transmission

to set the transmission

will be shown on the display.
to enable the key lock

; then press

)

)

appears
13