Connecting The Microphone And Attaching The Transmitter; Switching The Transmitter On Or Off; Settings Via The Menu; Basic Settings And Reset - Monacor International JTS UF-20TB/5 Mode D'emploi

batteries in the pocket transmitter and insert the
transmitter into a charging slot Power is supplied
via the lateral contacts (4)
Used batteries and defective recharge-
able batteries must not be placed in the
household waste To protect the envi-
ronment, always take them to a special
waste disposal, e g collection container
at your retailer
3.3 Connecting the microphone and
attaching the transmitter
1) Connect a suitable microphone (
ter 2) to the mini XLR jack (9)
2) When all settings have been made on the
transmitter, use the clip on the rear of the
transmitter to attach it to your clothes (e g
belt or waistband)

3.4 Switching the transmitter on or off

1) Press the button
mitter The backlight of the display (12) lights
up for a few seconds When you press a button
(5, 10, 11), the backlight is switched on again
2) The display shows the following information:
Symbol Meaning
Transmission power Hi (high) / Lo (low)
Low-cut filter activated
Attenuation activated
AT
Key lock activated
Device name, to be edited as desired
UF-20TB
(10 characters)
Group number (1 ... 15)
G
Channel number (1 ... 63)
C
Transmission frequency
MHz
(530 . 0 00 ... 605 . 0 00 MHz)
Identification number
ID
Microphone sensitivity adjusted
dB
Battery status
full
...
discharged
Fig. 3 Display information
3) To switch off, keep the button
2 s until the display indicates
14
All manuals and user guides at all-guides.com
☞ chap-
(5) to switch on the trans-
pressed for
Power OFF

3.5 Settings via the menu

All settings are made via a menu:
1) To call up the main menu (Fig 1), keep the
button SET (11) pressed for two seconds until
the menu appears on the display (12)
2) Press the button  or  (10) to select the
desired menu item Then call up the menu
item with the button SET
3) To make the setting, press the button 
or 
4) If multiple setup functions are available for a
menu item (e g group number and channel
number), press the button SET to go from one
function to the next one
5) To save a setting, press the button SET The
display briefly indicates
main menu reappears
To exit a menu item without a change,
press the button
reappears
6) To exit the main menu, press the button
press the button  or  to select the menu
item and then press the button SET
Exit
All setting options via the menu can be found in
the following chapters

3.6 Basic settings and reset

1) If it is difficult to read the display, call up
the contrast setting via the menu item
:
Contrast
Contrast
10
Fig. 4
Press the button  or  to set the contrast
The display indicates the value adjusted
between 0 and 20 Press the button SET to
save the setting The main menu reappears
To deactivate the main menu, press the
button or to change another setting, press
the button  or  to select the corresponding
menu item and press the button SET
2) To set the time for the display backlight, go
to the menu item
Light Time
before the
Saving
(5) The main menu
or
: