Trouble Shooting - Imer Group HPSTAR 150-13 Manuel D'utilisation

10. TROUBLE SHOOTING

If, following several attemps, the engine of the high pressure washer still does not start, please refer
to following table. Then, if the high pressure washer cannot start, please contact the IMER FRANCE
reseller or the nearest After-Sales Service to get information and to be instructed with measures to
take.
THE ENGINE CANNOT START:
Make sure position of the CHOKE LEVER is
correct.
Make sure the fuel cock is opened.
Check fuel level.
Oil level too low (oil sensor security has
triggered).
Make sure the position of the engine switch is
correct.
Make sure the spark plug is not dirty.
Make sure the spark plug cap is correctly fitted.
THE ENGINE SUDDENLY STOPS:
Out of fuel
Oil level too low (oil sensor security has
triggered).
LACK OF POWER FOR THE ENGINE:
Air filter clogged
THE ENGINE DOES NOT RUN CORRECTLY OR STALLS:
The CHOKE LEVER was removed too early.
THE ENGINE CORRECTLY RUNS WHEN IDLE BUT SPUTTERS WHEN LOADED:
Engine speed is too low.
50
Put the CHOKE LEVER to the CHOKE
(CLOSED) position.
Open the fuel cock if is closed.
Fill up the tank in case it is empty. Do not overfill it
Check oil level and top up.
Put the ON / OFF switch to position ON
(START).
Remove the spark plug and clean the electrode.
Fit the spark plug cap in case it is removed.
Fill with fuel.
Check oil level and top up.
Replace the air filter
Leave the CHOKE LEVER in the CHOKE
(CLOSED) position until the engine runs regularly.
Move speed control to position FAST.