Imer Group HPSTAR 150-13 Manuel D'utilisation page 37

Do not screw it to check the oil level.
3. If the oil level is less than the bottom level [(d) Fig. 02], fill the oil sump with correct oil [Fig. 04]
up to the top mark [(c) Fig. 02].
Oil capacity (Top level)
HPSTAR 150-13
HPSTAR 200-15
HPSTAR 200-21R / HPSTAR 250-15 / HPSTAR 300-15
NOTE
Replace the oil as soon as it is contaminated (see the MAINTENANCE INSTRUCTIONS).
OIL RECOMMENDED FOR THE ENGINE
Prefer using Motul 4100 TURBOLIGHT 10W-40 or an SE class (API classification) equivalent oil or
an upper grade oil.
We recommend using SAE 10W-30 or 10W-40 oils, for general use and all temperatures. If you use
a single grade oil, select the correct viscosity for an average ambient temperature, depending on the
season. [Fig. 04]
4.2. OIL SENSOR SECURITY
•
The oil sensor security controls the oil level in the carter and automatically stops the engine if the
oil level is less than a pre defined level.
4.3. CHECK FUEL LEVEL (GASOLINE)
■ Never open the tank cap in when the engine is running or still hot.
■ Never fill the tank in when the engine is running or still hot.
■ Never smoke when filling the fuel tank in or if, in the vicinity, there are naked flames or if any
other conditions are met to start a fire.
□ Always fill up the tank in the open air.
□ Do not overfill the tank. Leave enough space so that the fuel can evaporate.
1. Always install the high pressure washer on a flat and stable floor.
2. Close the tank valve before filling the tank up.
3. Open the tank cap [Fig. 05];
4. Control the fuel level (95 or 98 unleaded fuel). If the fuel (unleaded fuel) level is too low, top up
using the convenient fuel (unleaded fuel) of the high pressure washer.
WARNING
0,6 L
1,0 L
1,2 L
37
F
EN
E
R