Imer Group HPSTAR 150-13 Manuel D'utilisation page 38

Fuel tank capacity (UNLEADED GASOLINE 95 or 98)
HPSTAR 150-13
HPSTAR 200-15
HPSTAR 200-21R / HPSTAR 250-15 / HPSTAR 300-15
NOTE
Do not forget to fit a filter on the filling hole before topping up with fuel [Fig. 06] to prevent dust,
dirts or any other foreign bodies from getting into the tank.
□ Carefully wipe off the fuel spilt on the ground before starting the engine.
4.4. CONTROLLING COMPONENTS
Before starting the engine, control the following points:
•
Fuel leaks on fuel pipes, etc;
•
Tightening of screws and nuts;
•
Parts damaged or broken;
•
Vicinity of the high pressure washer.
4.5. OIL OF THE HIGH PRESSURE WASHER PUMP
Once the engine has stopped and the HP pump has cooled down, make sure the oil level is half way
of the oil level gauge [Fig. 26] and [Fig. 27].
When topping up, please refer to the lubricant types listed in section « TECHNICAL DATA» and follow
the instructions stated in section « 8.7. CHANGING THE PUMP OIL ».
4.6. OIL OF THE REDUCTION GEARBOX (HPSTAR 200-21R)
Once the engine has stopped and the HP pump has cooled down, make sure the oil level is half way
of the oil level gauge.
When topping up, please refer to the lubricant types listed in section "TECHNICAL DATA" and follow
the instructions stated in section "8.8. CHANGING THE REDUCTION GEARBOX OIL".
38
WARNING
3,6 L
6,1 L
7,0 L