Imer Group HPSTAR 150-13 Manuel D'utilisation page 45

Operation to perform
Control all the components listed in section «PRE
OPERATION CHECKS»
Check the tightening of bolts, screws and nuts
Check the oil level and top up if necessary
Make sure the water filter is clean
Replace the engine oil (following the 20 first
operating hours)
Clean the air filter
Replace the air filter
Clean the spark plug and adjust the electrode gap,
if necessary
Control the fixing of the pump to the engine
Control the tightness of fittings
Replace the spark plug
Drain the water, clean the filter and the tank of the
fuel cock
Replace the fuel filter
Replace the fuel pipes
Clean the carbon deposit from the cylinder head
Clean the cylinder head
Control and adjust the valve clearance
Change the antivibratory mountings
Clean and adjust the carburettor
Inspect valve seats
Replace the pump oil (following the first 50 hours)
Have the engine overhauled
Replace the oil seals of the pump
Replace the thermal valve and the «easy-starter»
valve
Replace the water seals of the pump (max. 800 h.)
Replace the reduction gearbox oil
Operating hours
8 h 50 h 100 h 200 h 300 h 500 h 1000 h
(daily)
○
○
○
○
○
○
○
○
○
○
○
●
EN
○
○
●
●
●
●
●
●
●
●
●
●
●
●
45
F
E
R