Spypoint TINY-D Manuel De L'utilisateur page 6

10
POWER
The battery level is shown in the «Report» mode.
(4/4 = full, 1/4= low) When the battery level shows 2/4,
the camera will continue to take pictures but we strongly
recommend changing the batteries before they are empty.
AA batteries
This camera requires the use of 6 AA batteries (1.5V). The
use of alkaline or lithium batteries is strongly recommended.
Also note that the voltage of rechargeable AA batteries
(1.2V) is insufficient to power your SPYPOINT camera.
During the installation of alkaline batteries, place the switch
inside the battery case to "ALK" (i.e. alkaline). Insert the
batteries in the battery case as indicated and insert it inside
the camera (see figure below). Exact polarity must be
followed. We also recommend the use of new batteries to
ensure maximum performance of your camera.
Connector
Top
Connector
Lithium battery pack
The camera SPYPOINT TINY-D can be powered by a
rechargeable lithium battery LIT-09/LIT-C-8 (sold separately,
refer to the section "OPTIONS"). This type of battery is less
affected by cold temperatures and lasts up to 3 times more
than an alkaline battery. During the installation of lithium
battery, place the switch inside the battery case to "ALK"
(i.e. alkaline). Insert the battery in the case as indicated and
insert it inside the camera (see figure below)
Top
Connector
SPY SPY P P
Connector
INT INT
TM
11