Basic settings
en
Programme
no.
Combi programme
Frozen bake, up to
P 08
3 cm deep
QBasic settings
Y our appliance has basic settings that you can change
B a s i c s e t t i n g s
to suit your needs.
Setting
Options
Button tone
‚
Ž
*
Œ
Demo mode
ƒ
š"‹
* Factory setting (factory settings may vary depending on the appli-
ance model)
You can change the button tone on your appliance if
you wish.
Changing the button tone
The appliance must be switched off when you do this.
Press and hold the
<
1.
time for a couple of seconds.
will appear in the display.
‚
Touch the
button.
<
2.
Ž
will start flashing in the display.
Switch to
on the settings area.
Œ
3.
Touch the
button.
<
4.
The setting has been applied.
Touch the
/
button.
ƒ
s
5.
The button tone has been switched off.
You can change this setting at any time.
34
Cookware Weight range in
kg
Open
0.4 - 0.9
Switched on
Switched off
Button tone (will remain active for
the
<
and
ƒ
/
s
buttons)
The appliance is switched off. You
can use the buttons and the display,
but the buttons will not activate any
function on the appliance (i.e. the
microwave has no power).
Demo mode is mainly used by deal-
ers.
and
/
buttons at the same
ƒ
s
DCleaning
W ith good care and cleaning, your appliance will retain
C l e a n i n g
its appearance and remain fully functioning for a long
time to come. We will explain here how you should
correctly care for and clean your appliance.
:
Warning – Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
:
Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
:
Warning – Risk of serious harm to health!
The surface of the appliance may become damaged if it
is not cleaned properly. Microwave energy may escape.
Clean the appliance on a regular basis, and remove any
food remnants immediately.~ "Cleaning agent"
on page 34
:
Warning – Risk of electric shock!
Do not immerse the appliance in water or clean under a
jet of water.
Note: Unpleasant odours, for example after fish has
been prepared, can be removed very easily. Add a few
drops of lemon juice to a cup of water. Always place a
spoon in the container to prevent delayed boiling. Heat
the water for 1 to 2 minutes at maximum microwave
output.
Cleaning agent
To ensure that the different surfaces are not damaged
by using the wrong cleaning agent, observe the
information in the table.
Do not use:
Harsh or abrasive cleaning agents.
■
Metal or glass scrapers to clean the door panels.
■
Metal or glass scrapers to clean the door seal.
■
Hard scouring pads or sponges.
■
Cleaning agents with a high alcohol content.
■
Wash new sponge cloths thoroughly before use.
Area
Cleaning product
Appliance front
Hot soapy water: Clean using a dish cloth and
then dry with a soft cloth. Do not use metal or
glass scrapers for cleaning.
Appliance front with
Hot soapy water: Clean using a dish cloth and
stainless steel
then dry with a soft cloth. Remove splashes
and patches of limescale, grease, starch and
albumin (e.g. egg white) immediately. Corro-
sion can form under these patches or
splashes. Special stainless-steel cleaning prod-
ucts are available from the after-sales service
or from specialist retailers. Do not use glass
cleaners or metal or glass scrapers for clean-
ing.