Combi-Cooking Programme; Basic Settings; Overview Of The Basic Settings; Changing Basic Settings - Junker JG4119260 Manuel D'utilisation Et Notice D'installation

en Basic settings
Cooking food with the automatic programmes
Weigh the food.
1.
You require the weight in order to set the pro-
gramme.
Place the food on microwave-safe cookware and
2.
cover with a lid.
Add the volume of water in accordance with the
3.
manufacturer's instructions on the packaging.
10.6 Combi-cooking programme
With the combi cooking programme, you combine microwave and grill.
Programme Food
P08 Frozen bake, up to 3 cm deep
Cooking food using the combi cooking
programme
Take the food out of its packaging.
1.
Weigh the food.
2.
You require the weight in order to set the pro-
gramme.
11 Basic settings
You can configure the appliance to meet your needs.
11.1 Overview of the basic settings
Here you can find an overview of the basic settings and factory settings. The basic settings depend on the features
of your appliance.
Setting
Button tone
Button tone
Demo mode
Factory setting (may vary according to model)
1
11.2 Changing basic settings
Requirement: The appliance is switched off.
Press and hold and
1.
a The display shows the first basic setting.
Press ⁠ .
2.
a The current value flashes on the display.
3. Use the settings area to set the required value.
Press ⁠ .
4.
a The appliance implements the setting.
Press ⁠ .
5.
Tip: The setting can be changed at any time.
38
Selection Meaning
1
Switch on the button tone.
Switch off the button tone.
Note: The button tone remains active for
⁠ Activate or deactivate demo mode.
Note: The appliance is switched off. You can use the buttons and the display,
the buttons do not work. Demo mode is mainly useful for dealers.
for a few seconds.
Set the programme. → Page 36
4.
Once the programme has finished, stir the food
5.
again.
The food should be left to stand for an additional 5
6.
to 10 minutes until it reaches a uniform temperature.
The cooking results are dependent on the food
quality and consistency of the food.
Cookware
Open
Place the food in microwave-safe, heat-resistant
3.
cookware that is not too big.
Set the programme. → Page 36
4.
Once the programme has finished, leave the food to
5.
rest for another 5–10 minutes to allow the temperat-
ure to even out.
and
11.3 Changing the signal duration
When your appliance is switched off, you hear an aud-
ible signal. You can change the duration of the signal.
Press and hold
▶
a The signal duration switches between short and
long.
a The appliance applies the signal duration and dis-
plays the time.
11.4 Setting the time
Note: After connecting the appliance to the power or
following a power cut, a signal sounds and several
zeros are shown on the display. It may take a few
seconds until a signal sounds and you can set the
time.
Weight range in kg
0.40–0.90
⁠ .
for approx. six seconds.