Fault Table; Trouble Shooting - Junker JG4119260 Notice D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Area
Cleaning product
Cooking compart-
Hot soapy water or vinegar solution: Clean
ment made of stain-
using a dish cloth and then dry with a soft
less steel
cloth.Do not use oven spray or any other
aggressive oven cleaners or abrasive materi-
als. Scouring pads, rough sponges and pan
cleaners are also unsuitable. These items
scratch the surface. Allow the interior surfaces
to dry completely.
Recess in the cook-
Damp cloth: Water must not be allowed to run
ing compartment
into the appliance through the turntable drive.
Dry the turntable drive with a cloth.
Turntable and roller
Hot soapy water: When placing the turntable
ring
back into its recess, it must engage properly.
Wire rack
Hot soapy water: Soak and clean with a dish
cloth or brush. Do not scour.Do not use metal
or glass scrapers for cleaning.
Door panels
Glass cleaner: Clean with a dish cloth. Do not
use glass scrapers.

3Trouble shooting

I f a fault occurs, there is often a simple explanation.
T r o u b l e s h o o t i n g
Before calling the after-sales service, please refer to the
fault table and attempt to correct the fault yourself.
Tip: If a dish does not turn out exactly as you wanted,
refer to the following chapter, where you will find lots of
tips and notes relating to the optimum
settings.~ "Tested for you in our cooking studio"
on page 37

Fault table

Fault
The appliance is not working
Three zeros are lit on the display.
The appliance is not operating. A
cooking time is shown on the display.
The microwave is not working.
It is taking longer than usual for food
to heat up
The turntable is making a scraping or
grinding noise.
Possible cause
The plug is not plugged into the mains
Power failure
The circuit breaker/fuse is faulty
Faulty operation
Power failure
The settings area has been actuated inadvertently.
<
The "
" field was not pressed after setting.
The door has not been properly closed.
The "
<
" field was not pressed.
The microwave power output has been set too low.
A larger amount of food than usual has been placed in
the appliance.
The food was colder than usual.
Dirt or debris in the area around the turntable drive.
Aquaclean cleaning programme
Add a few drops of washing-up liquid to a cup of
1.
water. Place a spoon into the container as well to
prevent delayed boiling.
Touch the
field.
>
2.
The appliance will switch off automatically after approx.
8 minutes.
Then wipe around the cooking compartment using a
soft cloth and allow it to dry thoroughly.
:
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by
one of our trained after-sales technicians. If the
appliance is defective, unplug the appliance from the
mains or switch off the circuit breaker in the fuse box.
Contact the after-sales service.
Remedy/information
Connect the appliance to the electricity supply
Check whether other kitchen appliances are working
Check in the fuse box to make sure that the circuit
breaker/fuse for the appliance is in working order
Switch off the circuit breaker/fuse for the appliance in
the fuse box and switch it back on after approximately
10 seconds
Reset the time.
Touch the "
a
<
Touch the "
the "
a
/
s
" field.
Check whether food remnants or debris is/are
trapped in the door.
Touch the "
<
Select a higher microwave power setting.
Double the amount – double the time.
Stir or turn the food during heating.
Clean the roller ring and the recess in the cooking
compartment.
Trouble shooting
/
s
" field.
" field or delete the setting by touching
" field.
en
35

Publicité

Table des Matières
loading

Table des Matières