shark Evo-GT V02 Manuel D'utilisation page 37

THE TEXTILES
The Evo-ES make it easy for you to appre-
ciate fully the performance of your helmet.
The parts in contact with the skin are
made in a fabric that is guaranteed to feel
pleasant, to absorb perspiration well and to
resist wear satisfactorily. We treat surfaces
to limit the risk of mould and bacteria.
WARNING! Although they are selec-
ted for their quality of resistance and
satisfactory wear, all the interior padding is
subject to normal wear depending on use
and care and maintenance, the length of use
and also the degree of acidity of your perspi-
ration. If you note any wear, we
advise you to replace the interior padding
in order to keep your helmet perfectly clean
and comfortable.
Your SHARK supplier can propose you with
replacement parts and also offer you cheek
pads of different thicknesses and densities,
should the standard selection not corres-
pond to the contours of your face.
CLEANING THE INTERIOR
The interior textile parts are washable; it is
important to follow the instructions below
scrupulously to avoid damaging them:
The cheek pads and head section must be
hand washed in warm, soapy water (maxi-
mum 30°). Do not use aggressive deter-
gents but either a product for delicate
materials in low dilution or household
soap.
TEXTILE PARTS / EASY FIT
It is essential to dry textile and foam parts
completely before using them. They must be
dried at room temperature. Never iron textile
parts. For parts with a leather appearance
or textiles attached to safety elements, use
a slightly damp sponge or cloth and house-
hold soap and rinse with clean water.
allowing too much water to come into
contact with polystyrene parts.
WARNING! It is essential to ensure
that all interior parts are perfectly
dry before using the helmet. The battery
feeding the LED as its electric cable could
be damaged by the moisture of fabrics and
corrode.
EASY FIT
Your SHARK have been designed to provide
additional comfort for eyeglasses wearers with
the SHARK EASY FIT.
Avoid
17