Connection With The Mains; Dmx-512 Connection / Connection Between Fixtures - Futurelight LB-12 REB LED-BAR Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable
Pin
Brown
Live
Blue
Neutral
Yellow/Green
Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

DMX-512 connection / connection between fixtures

The wires must not come into contact with each other, otherwise
Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
International
L
N
the fixtures will not work at all, or will not work properly.
26/63
00032426.DOC, Version 1.0

Publicité

Table des Matières
loading

Table des Matières