Publicité
①
4
②
③
④
English
TO OPEN/CLOSE SHIELD
To open, push the shield latch lever up and the shield will open slightly
Then pull the bulge on the shield slightly outward so the shield clears the latch
②
post on the helmet
, and raise the shield.
WARNING:
Do not attempt to open the shield without using the latch system, or
push down on the shield latch lever
To close, push the shield down until the latch post fully engages the shield and
the latch lever captures the bottom of the shield
WARNING:
Be sure to latch the shield properly before riding. If not latched
securely, the shield may open unexpectedly from wind pressure, vibration
or even normal head movement.
WARNING:
If your shield becomes too scratched or uncleanable, replace it with
a new one. Impaired visibility causes accidents. Use a solution of mild soap or
detergent and lukewarm water to clean your shield. Rinse well with clean water,
and wipe off with a soft cloth. Never use petrol, thinner, benzene or any other
solvents. There are many "aggressive" cleaners on the market, including some
supposed to be specifically for use on shield. Arai strongly recommends that you
do not use any such products to clean your shield as some of their ingredients
may have damaging effects on the shield and other plastic parts installed on your
helmet. Do not apply stickers or adhesive tape to the shield, as this will weaken
the hard coating. If tinted, the shield is for daylight use only.
③
, as damage to the latch system may occur.
④
.
①
.
Publicité
Chapitres
