Arai Helmet RX-7V Instructions D'utilisation page 10

①
④ ⑤
⑦
⑩
10
②
⑥
⑧
⑪
English
TO REMOVE/REPLACE SHIELD
To remove, place shield in the fully open position ① . Push the side pod
③
release lever from the front edge of the side pod backward ② to release
the side pod ③.
Then lower the shield until the brass stud of the shield moves into the red
hole of the base plate ④. Remove the shield from the spring clips ⑤ & ⑥ ,
and repeat for the other side.
To replace, position the shield on the base plate so that the lower part of
⑨
the sliding slot of the shield is over the spring clip of the base plate and the
brass stud is in the red hole of the base plate ⑦ . Press the shield onto the
spring clip, and then fully raise the shield until the brass stud falls into the
sliding slot of the base plate ⑧ & ⑨ . Position top hook on the backside of
the side pod into the top tab of base plate ⑩ , align the side pod with the
recess of the helmet shell and push the lower part of the side pod down
firmly until it clicks into place and is fully captured by the base plate ⑪ .
⑫
Repeat for the other side. Work the shield up and down to confirm proper
operation ⑫ .