Hauff-Technik HSI150-2SGi Instructions De Montage page 11

HRD 150/160 - 2SGi
Press firmly into the wall insert with both of your thumbs,
8
starting from the lower area of the press seal upwards (in
the direction of the split cut) along its circumference until
the press seal engages flush in the wall insert.
Finally, tighten all the Allen screws of the press seal in a cross-
9
wise sequence until the relevant torque is reached (see table).
Tighten the Allen screws evenly so that the press
plates do not overlap.
Subject to change!
Service telephone +49 7322 1333-0
As indicated in the instructions for use, our products have been designed exclusively for installation
in buildings made from state-of-the-art construction materials. We do not accept liability for use
deviating from or beyond this unless our express written confirmation has been obtained in advance.
11
EN