Wolf ICBCT15E Guide D'utilisation Et D'entretien page 18

W O L F
S O U N D
The electric cooktop is equipped with the
ability to change the volume and frequency, or
tone, of the touch controls through the user
option, activated through the timer controls.
To turn on user option, the cooktop must
be in Idle mode.
Touch and hold
turn on the volume adjustment option. The
three-digit display will show "Uol."
Touch and hold
seconds to turn on the frequency adjust-
ment option. The three-digit display will
show "FRE."
Both the volume and frequency are adjusted
using the "+" and "–" touch pads. One touch
equals one step up or down in volume or
frequency. The triple-zone element power bar
indicator graph will show the current status of
the volume or frequency and will change with
the user's input. (1 bar = low, 8 bars = medium
and 16 bars = high.)
As the volume/frequency is adjusted, the
cooktop will beep with each change. The beep
will represent the volume/frequency level that
is currently displayed by the power bar graph.
To exit the user option and return the
cooktop to Idle mode, touch and hold
Or, if no touch pad is touched for 10
seconds, the level is then stored and the
cooktop returns to Idle mode.
18
E L E C T R I C C O O K TO P
C O N T R O L
for 3 seconds to
for more than 5
for more than 7 seconds.
U S E & C A R E
C O O K TO P
C E R A M I C G L A S S T O P
Lock the cooktop before cleaning by touching
and holding the
Clean the top surface thoroughly before
operating the cooktop for the first time. Apply
approximately 5 ml of nonabrasive cleaner to
the surface of the ceramic glass with a lightly
dampened clean cloth. Use a second clean
cloth to remove any remaining cleaner residue.
Wipe the cooktop surface with a dry cloth to
completely eliminate any remaining moisture.
The cooktop should be cleaned after each use.
To avoid personal injury, be careful not to wipe
or clean any hot areas. It will be safe to clean
each element area whenever the hot-surface
indicator light has gone out.
To remove heavy or burned-on spills, allow the
cooktop to cool. Use the razor blade scraper
provided with the cooktop to scrape off any
burned-on substances. Remove any remaining
residue using the cleaning method described
above.
Pitting of the ceramic glass is possible if
spills with a high sugar content are left in
the hot zone. Use the razor blade
provided to move the spill to a cool area
for cleaning after the cooktop cools.
C O O K T O P F R A M E ( F R A M E D M O D E L S )
For general cleaning after each use, apply a
nonabrasive cleaner to the stainless steel
cooktop frame and gently wipe with a clean
towel or cloth. Be sure to remove any cleaner
residue from the frame and ceramic glass
surface before using the cooktop.
C L E A N I N G
symbol for 3 seconds.