Wolf ICBCT15E Guide D'utilisation Et D'entretien page 13

W O L F E L E C T R I C C O O K TO P
C O N T R O L O P E R AT I O N
The Wolf electric cooktop operates by using
high-frequency pulsation, cycling the heating
elements between zero power and full power.
As the heat is increased on the control panel,
the element will stay at full power for longer
periods and have shorter periods of zero
power.
When using the dual-zone or triple-zone
elements, all sections of the element will cycle
at the same rate. For safety reasons, the outer
elements cannot be turned on independently
from the center section.
T O U C H C O N T R O L PA N E L
The control panel of your electric cooktop is
illuminated for instant visual indication that
one or more elements are in use. The control
panel features touch controls with graduated
control lighting. The illustrations below show
the control panel of Model ICBCT36E.
Touch control panel
U S E & C A R E
M O D E S O F O P E R AT I O N
L O C K M O D E
In Lock mode, all touch pad operations on
the control panel are disabled and all heating
elements are turned off. A steady glowing light
within the
unit is locked. Refer to the illustration below.
To lock the control panel, touch and hold
for 3 seconds. The unit will beep
three times and the light within the
symbol will illuminate. The control unit is
now in Lock mode.
To unlock the control panel, touch and
hold
beep twice and the light within the
symbol will go out. The control unit is now
in Idle mode.
IMPORTANT NOTE: When the unit is powered
up for the first time or if there has been a
power outage for longer than 5 seconds, the
cooktop will default to Lock mode.
I D L E M O D E
After unlocking the control panel as described
in Lock Mode, the unit enters the Idle mode of
operation. The only valid touch pad operations
are for each element, the
the timer functions.
Lock key
touch pad
Lock mode key touch pad
symbol indicates that the
for 3 seconds. The unit will
and
13