Before Use - Metabo HPT DV 18DGL Instructions De Sécurité Et Mode D'emploi

English
NOTE
The charging time may vary according to temperature
and power source voltage.
4. Disconnect battery charger from the receptacle.
CAUTION
Do not pull the plug out of the receptacle by
pulling on the cord.
Make sure to grasp the plug when removing from
receptacle to avoid damaging cord.
5. Remove the battery from the battery charger.
Supporting the battery charger with hand, pull out the
battery from the battery charger.
NOTE
After operation, pull out batteries from the charger
fi rst, and then keep the batteries properly.
How to make the batteries perform longer.
(1) Recharge the batteries before they become
completely exhausted.
When you feel that the power of the tool becomes
weaker, stop using the tool and recharge its battery.
If you continue to use the tool and exhaust the electric
current, the battery may be damaged and its life will
become shorter.
(2) Avoid recharging at high temperatures.
A rechargeable battery will be hot immediately after
use. If such a battery is recharged immediately after
use, its internal chemical substance will deteriorate,
and the battery life will be shortened. Leave the
battery and recharge it after it has cooled for a while.
CAUTION
● When the battery charger has been continuosly
used, the battery charger will be heated, thus
constituting the cause of the failures. Once the
charging has been completed, give 15 minutes
rest until the next charging.
● If the battery is charged while it is heated
because it has been left for a long time in a
location subject to direct sunlight or because
the battery has just been used, the pilot lamp of
the charger lights for 1 second, does not light for
0.5 seconds (off for 0.5 seconds). In such a case,
fi rst let the battery cool, then start charging.
● When the pilot lamp fl ickers (at 0.2-second
intervals), check for and take out any foreign
objects in the charger's battery connector. If
there are no foreign objects, it is probable that
the battery or charger is malfunctioning. Take it
to your authorized Service Center.
12
● Since the built-in micro computer takes about
3 seconds to confi rm that the battery being
charged with UC18YKSL is taken out, wait for a
minimum of 3 seconds before reinserting it to
continue charging. If the battery is reinserted
within 3 seconds, the battery may not be properly
charged.

BEFORE USE

Check the work area to make sure that it is clear of debris
and clutter.
Clear the area of unnecessary personnel. Ensure that
lighting and ventilation is adequate.
OPERATION
1. Confi rm the clutch dial position (see Fig. 5)
The three modes of screwdriver, drill and hammer drill
can be switched by the position of the clutch dial in
this unit.
(1) When using this unit as a screwdriver, line up the one
of the numbers "1, 4, 7 ... 22" on the cap, or the black
dots, with the triangle mark on the outer body.
(2) When using this unit as a drill, align the clutch dial drill
mark " " with the triangle mark on the outer body.
(3) When using this unit as a hammer drill, align the clutch
dial hammer mark " " with the triangle mark on the
outer body.
Hammer mark
Weak
Strong
Clutch dial
CAUTION
● The clutch dial cannot be set between the numerals
"1, 4, 7 ... 22" or the black dots.
● Do not use with the clutch dial numeral between
"22" and the black line at the middle of the drill
mark. Doing so may cause damage (See Fig. 6).
Triangle mark
Drill mark
Fig. 5