Installation - Sirius SILT26 Instructions D'utilisation Et Avis De Montage

INSTALLATION

At tge beginning make sure that the packa-
ge is intact and all the parts are unbroken,
otherwise stop the installation and contact
the dealer. The manufacturer is not re-
sponsible for damages caused by material
handling or product installation.
Before installing the appliance read all
these instructions carefully.
WARNING: This product is made of cera-
mics, for that reason it requires an appro-
priate and accurate handling, as well as a
professional and accurate installation.
Extract the product from the packaging and
lay it on a suitable place, a soft material such
as sponge or fabric should be used to place
the product on it.
By using the supplied drilling jig, perforate
the wall according to the four pattern indi-
cated by the jig itself. The center of the dril-
ling jig should correspond to the center of the
cooktop. Insert the supplied dowel into the
holes made, tighten them, but do not tighten
until they are flush; the three screws into the
dowels corresponding to the holes with di-
scharge head (Fig.8 A) leaving the hole for the
locking screw empty (Fig. 9 B) because it will
be added later.
Place the ceramic cover over the suctioning
element and insert the steel cables into the
three holes of the ceramic, as shown in the
figure (Fig. 1). Put the power cable through
the air outlet grill, see Figure 2 The ceramic
part must perfectly cover the metal part na-
med "D" in the exploded view.
Extract from the packaging the ceramic co-
ver for the ceiling plate (see the detail B on
the exploded view), place the cover over the
hood and put the steel cables through the th-
ree holes in the ceramic body, the power ca-
ble should be put through the central hole of
the ceramic, see Fig.3. Extract the metal plate
from the packaging and then put the steel
cables through the appropriate supports, as
shown in figure 4.
Adjust the height of the product scrolling the
steel cables up and down inside the support,
it is necessary to unscrew and push the sup-
port in order to allow the scrolling of the ca-
ble, see fig. 5.
Check that the remaining length of ste-
el cables from the supports indicated in fig.
6 is the same, in order to ensure that it will
be installed perfectly parallel to the cei-
ling. Tightening the appropriate support by
screwing it as shown in fig.6, block the steel
cables. Add the clips as a further safety pre-
caution for cable blocking fig. 7. Put the hood
near the ceiling and hook the plate to the
screws previously installed (fig.8 A) Tighten
the three screws fixing the plate to the cei-
ling, then block the hood definitively adding
the security screw , see fig.9 B. Connect the
appliance to the electric grid.
Lift up the ceramic cover until reaching the
ceiling (fig.10 ), make sure that the springs
have hooked the ceramic cover.
In case the ceramic cover of the body, is not
perfectly flat or parallel to the body, it is pos-
sible to make an adjustment after installation.
Remove the grease filter as described in
Maintenance Section, remove the three pla-
stic caps shown in Figure 13 A. Using a Phil-
lips screw head screwdriver, tighten or loosen
the three screws in order to raise or lower the
ceramic body on a specific side (fig. 14). After
the adjustment insert the rubber tips and the
grease filter again.
15