Working - Sirius SILT26 Instructions D'utilisation Et Avis De Montage

WORKING

Remote control (Fig.11)
channel radio control for cooker hood remo-
te.
At first ignition, keep pressed the lighting
button for 5 seconds.
RC001
R C
ADIO ONTROL
Radio control used for the remote operation of duct-
ed cooker hoods.
T
ECHNI I CAL DATA
- Alkaline battery powered
- Operating frequency
- Combinations
- Max. consumption
- Operating temperature
- Dimensions
O D
PERATI I NG ESCRI I PTI I ON
The transmitter is equipped with 5 buttons for cook-
er hood management, as specified below:
: Light ON/OFF command.
: Motor ON (speed level 1) / OFF command.
: Reduce speed.
: Increase speed.
: 10-minute timer.
I O
NI I TI I AL PERATI I NG CONDI I TI I ON
The manufacturer supplies the radio control unit
ready to be used with codes preset in the Factory.
OPERATION MODE
Standard confi i gurati i on:
Standard configuration requires all "cooker hoods –
radio control - system" to be provided with the same
transmission code. In the event two cooker hoods –
radio control system are installed in the same room
or nearby, each system may affect the operation of
the another. Therefore, the code of one radio control
system must be changed.
Generati i ng a new transmi i ssi i on code:
The radio control system is provided with preset
codes. Should new codes be required, proceed as
follows: Press simultaneously buttons:
for two seconds. When Leds light on, press buttons:
(within 5 seconds). Leds flashing 3 times indicate
the procedure is completed.
WARNING! This operation deletes permanently the
preset codes.
16
GB
: 12 V mod. 23 A
: 433.92 Mhz
: 32.768
: 25 mA
: -20 ÷ + 55 °C
: 120 x 45 x 15 mm.