Installation; Installing Housing; Electrical Connection - Maico ECA 100 ipro Instructions De Montage Et Mode D'emploi

7. Installation

For installation with window installa-
tion kit FE 100/1 or spacing frame
ECA-DR  dedicated mounting
instructions.

7.1 Installing housing

1. Insert housing [1] into wall breakthrough/
wall sleeve (TOP must be at top).
2. Align housing horizontally and mark the
two dowel holes ( arrows).
3. Remove housing [1], drill M6 dowel holes
with a Ø of 6 mm and insert dowels.
4. Push cable grommet [3] carefully out of
housing and remove.
Danger of short circuits and
NOTICE
damage to unit! Water will
penetrate if the power cable
is incorrectly fed into the fan
housing or if the cable grom-
met is not fitted correctly.
Cut off cable grommet cap [3]
such that the cable grommet fits
tightly round the power cable.
Cut off at least 5 mm of the cap
(power cable can bend better
and electronics cover [4] can be
positioned correctly).
Fit cable grommet [3] correctly,
seal on both sides if required.
5. Insert cable grommet into housing.
Guide power cable into connection
area such that the cable grommet
fits around the cable sheathing
completely and does not penetrate
too far into the connection area.

7.2 Electrical connection

Danger to life from electric
shock.
Switch the mains fuse off.
DANGER
Unit damage in the case of
NOTICE
short-circuits.
Insulate PE conductor and
unneeded cable cores.
1. Only lay single cable cores in the unit. To
do this, reduce power cable sheathing to a
length of 100 mm. Strip single cable cores
to 9 to 10 mm.
2. Insert housing [1] into wall breakthrough/
wall sleeve and secure with two screws.
Do not insert the housing such that it is
twisted or crushed. Make sure you use
mounting material which is sized for the
purpose.
3. Electrically connect power cable to spring
clip [13] according to connection wiring
diagram [14], also see wiring diagrams in
Chapter 13.
7. Installation │ UK
17