Publicité
Installation
10. Remove four top stand-
off s from fi replace and
discard.
11. Place fi replace
on top of bottom
section but do not
place against wall.
12. Stop and fi nish electrical and gas installation while
you have room (see "Electrical Wiring" and "Gas Sup-
ply" in the LX1 Installer's Manual).
13. Once complete,
place fi replace
fully against the
wall (standoff s
between studs).
X
X
X
X
14. Flatten front
feet of fi replace
down and screw
feet to the bot-
tom section with
self-drilling sheet
metal screws (max
1" length).
15. Place shims on top
of the fi replace,
avoiding plac-
ing the shims on
screw heads (min
1/4"). Place middle
section on top
of fi replace with
fl anges around the
wall studs.
16. Screw the middle
section in line to
the wall, through
the studs, to pull
the middle section
snug against the
studs.
Steel Framing Kit
5
Publicité
