Marshall CODE 50 Manuel D'utilisation page 9

FRONT PANEL FUNCTIONS (CONT.)
15. PRE FX
This is where you will find FX that would typically plug into a conventional amplifier
between the guitar and the amplifier's input. These FX would typically be in pedal form,
and also known as 'stompboxes' . The 'stompbox' FX in the PRE FX section are:
Compressor
Compressor affects an audio signal's dynamic range. CODE's compressor decreases,
or 'compresses' , any part of your guitar sound that peaks above a certain threshold.
Any part of your guitar sound that remains below the threshold is unaffected.
Compressor can add clarity and consistency to your guitar sound whether clean or
overdriven. Compressor's editable parameters are:
PARAMETER VALUE RANGE
Tone 0 - 10
Ratio 0 - 10
Compression 0 - 10
Level 0 - 10
Distortion
CODE's stompbox Distortion's three Modes simulate solid-state Distortion and
Overdrive FX pedals. GUV Mode is a Marshall Guv'nor™ with Drive and Tone
controls. ODR & DIS Modes provide flavours of classic overdrive and distortion
stompboxes. Stompbox Distortion is particularly effective when used with classic
and vintage MST preamp models to provide more drive and sustain. Distortion's
editable parameters are:
PARAMETER VALUE RANGE
Mode GUV, ODR & DIS
Drive 0 - 10
Tone 0 - 10
Level 0 - 10
'STOMPBOX' FX
DESCRIPTION
Adjusts the Compressor's higher and lower
frequencies.
Controls how much Compression is applied to a signal
above the threshold.
Adjusts the point at which Compression is applied to
the signal.
Controls the overall volume level of the Compressor.
DESCRIPTION
Marshall Guv'nor, Classic OD pedal
& Classic Distortion pedal.
Controls the amount of Overdrive or Distortion
applied to the signal.
Adjusts the amount of upper mid and higher frequency
content in the Overdrive or Distortion before the
signal reaches the amplifier panel tone controls.
Controls Distortion's overall volume level.
ENGLISH
A: >>|<< A: >>|<<