Miele PFD 104 SCVi Mode D'emploi page 36

en - Before using for the first time
Basic settings
Switching on the dishwasher
 Open the door.
 Switch the dishwasher on using the
 sensor control.
The welcome screen will appear when
the dishwasher is switched on and the
welcome melody will sound.
Setting the language
The display will then change automatic-
ally to the screen for setting the lan-
guage.
 Select the language you want as well
as the country, if appropriate, using
the  sensor control and confirm
with OK.
A tick  will appear next to the language
that has been set.
Setting up Miele@home
The message
Miele@home
the display.
 To set up Miele@home now, confirm
by touching OK.
Tip: To postpone setup until later, select
the option and confirm by touching
Skip
OK.
There are two ways of connecting your
dishwasher to your WiFi network:
 Select the connection method you
want and confirm your choice with
OK.
1.
Connect using App
2.
Connect using WPS
(WPS = WiFi Protected Setup)
You will then be guided by the display
and the relevant Miele app.
36
will appear on
Setting the time of day
The time of day is set automatically if a
connection is established with the
WiFi network.
The display will then change to the
screen for setting the time of day.
The current time of day must be set be-
fore you can use the timer option.
 Use the  sensor controls to enter
the hour and confirm your entry by
touching OK.
 Then set the minutes and confirm
with OK.
Holding down the relevant  or
 sensor control will increase or de-
crease the time automatically.
Setting the water hardness
The display will change to the screen for
setting the water hardness.
- You should programme the dish-
washer to the correct water hardness
for your area.
- Your local water authority will be able
to advise you on the water hardness
level in your area.
- Where the water hardness fluctuates,
e.g. between 1.8 and 2.7 mmol/l (10–
15 °dH – German scale), always pro-
gramme the dishwasher to the higher
value (2.7 mmol/l or 15 °dH in this ex-
ample).
In the event of a fault, it will help the
service technician if you know the water
hardness of your local water supply.
Therefore, please enter the water hard-
ness:
____________ °dH