en - Warning and Safety instructions
The dishwasher must not be used if the electrical connection cable
is damaged. A damaged connection cable may only be replaced by a
suitable connection cable of the same type. For safety reasons, such
replacement may only be carried out by the Miele Customer Service
Department or a qualified service technician.
The dishwasher must be disconnected from the mains electricity
supply before any maintenance or repair work is carried out.
The plastic housing of the water connection contains electrical
components. It must not be dipped in water.
There are electrical wires in the water inlet hose. Do not shorten
the water inlet hose, even if it is too long.
The integrated Waterproof system offers protection from water
damage, provided that the following conditions are met:
- Installation has been carried out correctly.
- The dishwasher is properly maintained and parts are replaced
where it can be seen that this is necessary.
- The stopcocks have been turned off during longer periods of in-
activity (e.g. whilst on holiday).
The Waterproof system will work even when the dishwasher is
switched off. However, the dishwasher must remain connected to the
electricity supply.
While the dishwasher is under warranty, repairs should only be un-
dertaken by a Miele authorised service technician. Otherwise the
warranty is invalidated.
Correct use
This dishwasher is designed for operation with water and deter-
gents suitable for use in commercial dishwashers only. Organic
solvents and flammable liquid agents must not be used in it.
This could cause an explosion, damage rubber or plastic components
in the dishwasher and cause liquids to leak out of it.
You could injure yourself on the open dishwasher door or trip over
it. Avoid leaving the door open unnecessarily.
Do not sit, stand or lean on the opened door. This would tip or
damage the dishwasher.
After any plumbing work the water pipework to the dishwasher will
need to be vented. If this is not done, components can be damaged.
32