Publicité
– Heating/hot-water
service program
– Programme for hot-water service with
storage capacity boiler unit
– Setting the time
With the heating program it is possible to set the switching times of the temperature for a
period of a week. The weekly program consists of 7 daily programs. One daily program allows
3 phases of heating. Each phase is defined by a starting time and a finishing time. The n. 8 daily
program is for the hot-water service. If a phase is not required, the same starting and finishing
time may be entered.
Select the days that correspond with the heating phase.
4
1= Monday, ... 7 = Sunday/8 = hot-water service program
5
Start of phase 1: heating with fixed modality
6
End phase 1: heating with reduced modality
7
Start phase 2: heating with fixed modality
8
End phase 2: heating with reduced modality
9
Start phase 3: heating with fixed modality
10
End phase 3: heating with reduced modality
1 1
Copying of the daily program
By pressing this key it is possible to repeat the current heating program for
the next day.
By pressing this key it is possible to repeat the current heating program for
the previous day.
As a confirmation the following day is displayed.
With the Logic Remote Control it is possible to manage the temperature of boiler unit on two
levels (a comfort level and one at reduced temperature) in accordance with the programme
chosen with parameter 62 (load hot-water service). To have access to the parameter press
the
and
keys for at least 5 seconds and then go along the entered lines with the
key until parameter 62 is reached. At this point four different programs may be selected with
o
keys, with the following characteristics:
0 = 24 hours/ day - Hot water always available at the temperature set in parameter 3.
1 = standard - Hot water according to the daily heating program. In the comfort periods of the
heating the temperature of the boiler unit is regulated at the value set via parameter 61.
2 = service suspended.
3 = second daily program (8) - Everyday of the week the temperature of the hot-water servi-
ce is set according to program B. In this case the programming is one for all the days of
the week and three periods of time are available. In the periods of time set, the tempera-
ture of the boiler unit is controlled via the temperature setting of parameter 61.
5
Start phase 1: preparation of the boiler unit to the comfort temperature
6
End phase 1: Temperature of boiler unit maintained at the reduced value
7
Start phase 2: Preparation of boiler unit to the comfort temperature
8
End phase 2: Temperature of boiler unit maintained at the reduced value
9
Start phase 3: preparation of boiler unit to the comfort temperature
10
End phase 3: Temperature of boiler unit maintained at the reduced value
To set the current day of the week
12
(1 = Monday/7 = Sunday)
13
To set the current hour
To set the current minute
14
Once the hour is completed, the setting of the hour changes.
With
and
keys the current hour is regulated. Pressing these keys together, the
regulation is speeded up in an increasing sense.
ENG
FR
9
Publicité
