Publicité
Use
Before use, wash the cooking plate with warm, soapy water.
SWITCHING ON
− The appliance is ready for use.
− Open the valve on the gas cylinder.
− Open the plancha valve by turning the knob to the high flame position (image on
the ring around the knob).
− Once in this position, push in the knob and press the igniter switch to light the
burner. Check that the burner is completely lit by looking through the openings
on the side of the appliance.
− Keep the knob pressed in for 5 - 10 seconds to engage the thermocouple safety
system (see Figure 5).
− Then release the knob and wait for the burner to heat the cooking plate to the
required temperature.
− Preheat the plancha by setting the control knob to the high flame position for 5
to 10 minutes, then turn it to the low flame position.
− Your appliance is ready for use.
NOTES
The first time you use your plancha, you may notice some smoke and an odour from the
appliance. This is normal.
SWITCHING OFF
− After use, switch off the appliance by turning both knobs to the vertical
position, pointing to the image of a circle.
− Close the valve on the gas cylinder.
− Disconnect the supply hose from the appliance and store it in a dry, well-
ventilated location. The gas cylinder must also be stored in a dry, well-
ventilated location, away from sources of heat.
COOKING
With its two separate heating areas, this model allows two different types of food to be
cooked simultaneously, such as meat or fish on one side and vegetables on the other.
Preheat the plancha by setting the control knob to the high flame position for 5 to 10
minutes, then turn it to the low flame position.
- 23 -
Publicité
