SilverCrest SSSH 600 A1 Mode D'emploi Et Consignes De Sécurité page 31

Proceed as follows:
•
Pour the food to be processed into a suitable container.
•
Vertically guide the whisk (6) into the mixture.
•
Start the hand-held blender with the switch (2) and select a suitable speed with the speed controller (1).
Press and hold the switch (2) during operation. Reduce the speed if too much spray is produced.
•
To achieve consistent processing of the mixture, gently move the hand-held blender up and down.
•
Once the mixing result meets your requirements, release the switch (2) as long as the whisk (6) is still in
the mixture.
•
Wait until the whisk (6) has stopped before you remove it out of the processed food.
8. Cleaning
Risk of injury! Take care when cleaning the hand-held blender! The blade in the immersion
blender (5) is very sharp!
Warning of damage to property! Do not use any scratching or abrasive cleaning
agents or abrasive objects (such as a metal scourer) for cleaning purposes. Failure to do so
may cause the hand-held blender to become damaged.
It is recommended to clean the immersion blender (5) or whisk (6) directly after use in order
to prevent the processed foods from drying. In particular, after processing very salty foods the
immersion blender (5) or whisk (6) should be immediately rinsed with clean water.
•
Remove the plug from the socket.
•
Remove the immersion blender (5) or whisk (6) from the motor block (4).
•
Disconnect the whisk (6) from the adapter by removing the shaft of the whisk (6) from the adapter
holder.
•
Clean the motor block (4) and the adapter with a soft damp cloth and then dry it well. Cleaning in the
rinsing bath would result in irreparable damage!
•
You can clean the immersion blender (5), whisk (6) and measuring cup in a basin. After cleaning, rinse
with plenty of clean water to remove any detergent residue. Then thoroughly dry the immersion blender
(5), whisk (6) and measuring cup.
•
Alternatively, you can clean the immersion blender (5), whisk (6) and measuring cup in the dishwasher.
9. Storing the device when not in use
If the hand-held blender is not going to be used for a long period of time, clean it as described in the
previous section. Store this in a clean, dry location out of reach of children.
10. Troubleshooting
If your hand-held blender does not work as usual, use the following instructions to try and solve the
problem. If working through the following tips does not eliminate the fault, please contact our hotline (see
the 'Warranty information' section).
SilverCrest SSSH 600 A1
English - 29