SilverCrest SSSH 600 A1 Mode D'emploi Et Consignes De Sécurité page 26

SilverCrest SSSH 600 A1
DANGER of electric shock
• Only connect the hand-held blender to the mains once the motor
block (4) and immersion blender (5) or whisk (6) are assembled.
There is a risk of electric shock!
• Only plug in the hand-held blender to a power socket, which is
accordingly installed and easily accessible, whose mains voltage
corresponds with the rating plate specifications. Following
connection, the power socket must continue to be easily accessible
so that the plug can be quickly removed in an emergency.
• Never operate the hand-held blender in the vicinity of the bath,
shower or filled wash basin.
• The power cable and plug must not be damaged.
• If the connecting cable of this device is damaged, it must be
replaced by the manufacturer, their service department or by a
similarly qualified person in order to prevent any hazards.
• Never open the housing of the motor block (4), as this contains
parts to be maintained. If the housing is open, there is a risk of
electric shock.
• If you notice any smoke, unusual noises or smells, remove the plug
from the power socket immediately. In such cases you must stop
using the hand-held blender until it has been checked by a
technician. Do not inhale smoke possibly caused by a burning
device. If you have inhaled smoke, consult a physician. Inhaling
smoke can be harmful to your health, there is a risk of injury!
• Ensure that the power cable cannot be damaged by sharp edges
or hot surfaces. The power cable must not get jammed or
squashed. Always remove the power cable from the power socket
by the plug, never pull on the cable itself. Always lay the power
24 - English