Publicité
Move the external measuring jaws
together until they touch both sides of
the object you want to measure. Please
ensure that you do not damage the object
you want to measure by subjecting it to
too much pressure.
The LCD display
dimensions.
Measuring an object from the inside
(see Fig. C.2):
Place the internal measuring jaws
against the object you want to measure.
Move the internal measuring jaws
apart until they touch the object on both
its inner sides. Please ensure that you
do not damage the object you want to
measure by subjecting it to too much
pressure.
The LCD display
dimensions.
Measuring the depth of an object
(see Fig. E.1):
Move the depth-measuring blade
of the caliper.
Put the depth-measuring blade
position until it touches the surface (e.g.
inside a hole).
Slide the body of the caliper
until you feel resistance.
Ensure that you do not damage the
depth-measuring blade
you want to measure by exerting too
much pressure on them.
The LCD display
dimensions.
After measurement:
After carrying out the measurement, move
the external measuring jaws
measuring jaws
Switch the LCD display
pressing the ON / OFF key
Tip: The LCD display
switches itself off after approx. 5 minutes.
˜ Examples of use
Tip: When measuring, always proceed as
described in the chapter on using the caliper.
now displays the
5 ]
[
now displays the
5 ]
[
6 ]
[
now displays the
5 ]
[
together again.
2 ]
[
5 ]
[
automatically
[
5 ]
[
10 ]
[
2 ]
[
2 ]
[
6 ]
in
[
6 ]
downward
[
11 ]
or the object
/ internal
[
10 ]
off again by
.
[
9 ]
GB/IE/NI
out
15
Publicité
