Publicité
the battery and insert it again after waiting
more than 30 seconds.
Loosen the fixed screw
screwdriver (not included).
Remove the lid from the battery
compartment
Remove the old battery.
Insert the new battery into the battery
compartment and ensure correct
polarity (+ and –). Make sure that the
plus terminal points outwards.
Close the lid to the battery compartment
(see Fig. B).
[
7 ]
Tighten the fixed screw
screwdriver (not included).
˜ Preparing the caliper
Clean all measuring surfaces
depth-measuring blade
cloth. Otherwise, faulty measuring results
may occur due to, for example, humidity.
Check that all keys and the LCD display
work correctly.
[
5 ]
˜ Starting up the device
˜ Using the caliper
Remove the
use.
Push the external measuring jaws
the internal measuring jaws
Switch the LCD display
the ON / OFF key
Press the inch / mm key
of measurement (inch or mm) you wish to
use. Either "mm" or "in" will appear to the
right of the figures in the LCD display
Press the key to obtain the zero setting
(ZERO)
display
Tip: The LCD display
automatically switch on by moving the
internal measuring jaws
measuring jaws
Measuring an object from the outside
(see Fig. C.1):
Move the external measuring jaws
apart. Place the external measuring jaws
against the object to be measured.
[
10 ]
14
GB/IE/NI
(see Fig. B).
7 ]
[
insulation sheet before
4 ]
[
in order to reset the LCD
8 ]
[
to zero.
5 ]
[
.
10 ]
[
with
12 ]
[
with
12 ]
[
with a dry
[
6 ]
[
2 ]
on by pressing
5 ]
[
.
9 ]
[
to set the unit
3 ]
[
will also
[
5 ]
or the external
[
2 ]
and the
1 ]
[
and
10 ]
[
together.
5 ]
[
10 ]
[
.
Publicité
