Publicité
Installation
Installing the Dryer
Step 1: Position and Level the Dryer
For further assistance,
refer to section on Location
Requirements.
Install dryer before washer. This allows room for
attaching
exhaust duct.
Place the dryer in position,
and adjust the legs until the
dryer is level from side to side and front to back.
1
2
1
2
3
Dryer Base
Level
Leveling Leg
DRY687N
Figure 3
Step 2: Connect
Dryer Exhaust System
For further assistance,
refer to sections on Location
Requirements
and Dryer Exhaust
Requirements.
A clothes dryer produces
combustible
lint.
To reduce
the risk of fire and combustion
gas accumulation
the dryer MUST
be
exhausted
to the outdoors.
Wl16
•
DO NOT use plastic or thin foil ducting.
•
Locate dryer so exhaust duct is as short as
possible.
•
Be certain old ducts are cleaned
before installing
your new dryer.
•
Use 4 inch (10.2 cm) diameter
rigid or flexible
metal duct.
•
The male end of each section of duct must point
away from the dryer.
•
Use as few elbows as possible.
•
Use duct tape on all duct joints.
•
Ductwork
that runs through unheated
areas must
be insulated
to help reduce condensation
and lint
build-up
on pipe walls.
•
Failure
to exhaust
dryer
properly
will void
warranty.
Z_
DO
DON'T
DRY688N
Figure 4
NOTE:
Venting
materials
are not supplied
with the
dryer (obtain
locally.)
512023
© Copyright, Alliance Laundry Systems LLC - DO NOT COPY or TRANSMIT
9
Publicité
