Publicité
SteamForce Speed Pro
by the guarantee.
7. Preparation
Prepare the old wallpaper well so that you can remove it as quickly as possible
and thus in an energy-e cient way.
To achieve fast paper removal always gently score the areas to be
stripped. With heavily embossed, vinyl-coated or painted papers this is
essential. Either use a proprietary perforator tool or alternatively score
the paper with the edge of a wall scraper in a 'criss-cross' pattern with
15 cm spacing. As with all decorating work be sure to protect carpets
and furniture with covers.
8. Operation
•
Place the unit on a at surface near the area to be stripped.
•
Open the lid of the device and remove the hose, the steam plates and the power cable.
•
Hold the water tank by the sides and pull it out of the device (Fig. 3).
•
Place the water tank on a at surface with the tank opening facing upwards, unscrew
the tank cap and ll with clean water (no hot water). (Fig. 4). Do not use additives - do
not over ll.
•
Screw the tank cap back in place and check that it is tight.
•
Put the water tank back into the device.
•
Fully uncoil the hose and supply cord.
•
Screw hose onto threaded outlets of boiler and steamplate, securely by hand. Do not
overtighten (Fig. 5).
•
Connect the supply cord from the unit to the socket-outlet and switch on.
Caution! Beware of hot water discharge prior to steam emission.
•
lt can take up to 3.5 mins (approx.) before steam is produced - depending on ll water
temperature. DO NOT leave unattended.
•
Once steam is being produced at the steamplate you are ready to commence operation.
CAUTION!
CAUTION! WARNING: Hot liquid or steam can burn.
Danger of scalding! Steam may also condense into boiling
droplets. Steam should not be directed towards electrical
appliances.
•
Press the steam plate against the wall for a few seconds.
EN
23
Publicité
