SteamForce Speed Pro
f) Children shall not play with the appliance. Risk of scalding or shock.
g) Never use the tool in hazardous areas that contain ammable
liquids, gases or dusts. Power tools generate sparks that can ignite
dust or vapours.
h) If the supply cord is damaged, it must be replaced by the
manufacturer or its service agents to avoid a safety hazard.
4. Safety Instructions for Steam Wallpaper Strippers
! !
When working with hot steam (min.100°C), there is a risk of
ATTENTION
serious scalding. Hot steam and boiling water can emit when
the safety valve ( g. 1)is activated due to overpressure in
incorrect operation of the unit.
Only change position during use, with care. The steam unit,
hose and steamplate can be very hot. Always wear suitable
protective clothing / gloves.
Operate the unit only with pure water without agents or additives. Do not
switch the unit on when empty.
Never point the steamplate / bar at people, animals, at objects sensitive to
temperature or other electrical equipment. Do not point liquid or steam
directly at electrical devices or equipment containing electrical components,
such as the interior of ovens. Always ensure that the unit is standing
securely in a horizontal position (on the oor). (Fig. 2)
Be careful of overhead dripping, when using on overhead areas tilt the
steamplate away from the face and body and regularly empty the steamplate
of any collected condensation.
Always visually check that the hose and steamplate inlet are not blocked
before attempting to use.
Do not stand on or place objects onto the unit or steam hose. Never over-
twist or make kinks in the steam hose and never block the valve. Only carry
the device by the handles provided.
Never pull on the steam hose or supply cord. Whenever accessories are
replaced, during maintenance, when lling / re lling or draining, and
whenever the steam device is not in use (including breaks between work),
the plug on the mains cable must be removed from the socket. The device
must be kept out of the reach of children whenever it is switched on or
EN
21