Publicité
OPERATION
Function indicator symbols on the dis-
play
Meat probe connected*
Minute Minder active
Duration
Programme end
Child Lock Active
Oven pre-heat active
* availability depending on the model
Connect the power supply
When you connect the appliance to power (or
when power is restored after an outage), the
display will show 00:00 and you will need to
set the current time. You must set the current
time to use the appliance.
Note: In the event of a power outage, all
settings such as Duration, Temperature and
Heating Function will be lost. You will need
to re-enter the settings to continue cooking.
If the pyrolytic cleaning is interrupted (or the
door is locked for any other reason), the oven
will start the cooling and door opening pro-
cedure before you can set the time. A power
outage does not release the Child Lock, but it
becomes active only after setting the current
time and when the appliance is in standby.
Set the current time
When you connect the appliance to the power
supply, the hours 00: flash on the display. (mi-
nute digits are illuminated permanently). Use
and
to set the hour. Touch
firm the setting. . The minutes :00 flash on the
display.(the hour is illuminated permanently).
Use
and
to set the minutes. Touch
to confirm the setting. The appliance enters
standby mode. You will hear a beep when the
current time is stored in the appliance.
change the current time when the appliance
is on, touch and hold
be shown on the display. Touch the
once again and the digits will start to flash.
Now you can proceed to set the current time.
The display brightness.
The LED display brightness varies depending
on the time of day. The display is dimmed
during 22:00 to 06:00 and its brightness is
normal during 06:00 to 22:00. Also, the dis-
play is brighter when active than when the
appliance is in Standby mode.
Standby mode
Switch the appliance to standby mode to
reset all function settings, times, tempera-
ture and automatic programmes. All heating
elements are disconnected. The display is
dimmed except for the clock. In this mode,
only the
display. The sensor has reduced brightness.
The display is dimmed in this mode.
If the temperature in the chamber exceeds
80°C, the temperature and current time are
displayed alternately.
When Child Lock is on and you touch
the LOC message
displayed for 5 seconds instead of current
time/temperature.
to con-
86
. The
on/off sensor is available on the
and symbols will be
To
symbol will
sensor
,
Publicité
